Installing Portfow in GradeWork by Paragin allows portfolio snapshots to be submitted and graded seamlessly within GradeWork for (summative) assessment.

Note: Setting up Portflow in GradeWork might require the procurement of an additional connector in GradeWork. Please contact your GradeWork representative for more information.

Installation

I. Set-up GradeWork

To install Portflow in GradeWork, please follow the steps below and communicate the required information to Drieam. For more information on the set-up in GradeWork, please refer to the GradeWork knowledge base.

1. In GradeWork, navigate to Tenantinstellingen > LTI Instellingen.
2. Note all relevant tenant details to share with Drieam:
   1. Name
   2. IssuerId
   3. AuthUrl
   4. JwksUrl
3. Add a new tool via the + in the bottom-right corner.
4. Add the following information for Portflow:
   1. Name: Portflow
   2. Icoon: Portflow
   3. InitiateLoginUrl: https://app.portflow.app/lti/open_id
   4. MessageUrl: https://app.portflow.app/lti/launches

   5. JwksUrl: https://app.portflow.app/lti/keypairs

5. Note the tool details to share with Drieam:

   1. ClientId

   2. DeploymentId

Overview of information to send to Drieam

Please send the following information from the steps above to support@drieam.com:

1. Tenant details
   1. Name
   2. IssuerId
   3. AuthUrl
   4. JwksUrl
2. Tool details

   1. ClientId

   2. DeploymentId

3. Type of installation: production/acceptance/testing